This Honda Jazz is less than 2 year old but the paint work was already in quite a bad condition, the photo should pretty much tell the story.
Not only the paint work was full of water marks, someone actually tried to some ‘drawing’ on the bonnet.
Lastly swirls and scratches were found everywhere on the paint work.
The owner’s friends suggested to her that she should send the car for a re-spray but she thought she would like to let me have a go on the car first.
For the more serious areas, I used the Edge green wool pad on the rotary with Menzerna IP/RMG. Following that I went over with an orange pad on a DA with IP/RMG. Here are two photos showing the half/half before and after effect.
On the bonnet,
On the driver’s door,
And now we will go to the before and after photos,
Before
After
Before
After
Before
After
Before
After
Than I used Pink Moose (VM/RMG) with a green polishing pad on a DA to do a final pass and finished off with Carnauba Moose Wax using foam applicator. Here’s the end result,
Here’s a full sun shot on the bonnet,
And a couple of close-up
So in the end I think I managed to help the owner to save some money from re-spraying the car. Thanks for reading through the posting and I hope you guys will enjoy it.
Not only the paint work was full of water marks, someone actually tried to some ‘drawing’ on the bonnet.
Lastly swirls and scratches were found everywhere on the paint work.
The owner’s friends suggested to her that she should send the car for a re-spray but she thought she would like to let me have a go on the car first.
For the more serious areas, I used the Edge green wool pad on the rotary with Menzerna IP/RMG. Following that I went over with an orange pad on a DA with IP/RMG. Here are two photos showing the half/half before and after effect.
On the bonnet,
On the driver’s door,
And now we will go to the before and after photos,
Before
After
Before
After
Before
After
Before
After
Than I used Pink Moose (VM/RMG) with a green polishing pad on a DA to do a final pass and finished off with Carnauba Moose Wax using foam applicator. Here’s the end result,
Here’s a full sun shot on the bonnet,
And a couple of close-up
So in the end I think I managed to help the owner to save some money from re-spraying the car. Thanks for reading through the posting and I hope you guys will enjoy it.