Zaino and 3M UltraShield
- Thread starter RBW111
- Start date
klnyc
Deep scratch guy.
YOu should have no problem..I had it on my.
imported_memnuts
New member
Perfectly okay. Actually an excellent product to use because it will not leave a stain or deposits at the edge of the shield.
Be extremely careful when applying any protectant over a clear shield. They tend to marr alot easier than the painted surfaces. Use a fresh clean soft applicator.
Be extremely careful when applying any protectant over a clear shield. They tend to marr alot easier than the painted surfaces. Use a fresh clean soft applicator.
Deanski
STUTTGART'S FINEST
Clear sealants like Zaino... YES! Wax: NO!
The films are very soft and tend to grab MF fibers when warmed in the sun. Make sure it's really cool before application and take your time. It's soft and marring is very easy to do on these, but any good clear sealant will work fine as long as it doen't have a boat-load of solvents.
If you get some in the edge, carefully remove it by saturating the edge with Z6 and use a toothpick or eyebrow brush which has stiff brissles, but natural ones. You don't want to start lifting the film edge, work as close to level with the edge so not to produce lift. Use a MF towel on the finish to protect it as you work.
Regards,
Deanski
The films are very soft and tend to grab MF fibers when warmed in the sun. Make sure it's really cool before application and take your time. It's soft and marring is very easy to do on these, but any good clear sealant will work fine as long as it doen't have a boat-load of solvents.
If you get some in the edge, carefully remove it by saturating the edge with Z6 and use a toothpick or eyebrow brush which has stiff brissles, but natural ones. You don't want to start lifting the film edge, work as close to level with the edge so not to produce lift. Use a MF towel on the finish to protect it as you work.
Regards,
Deanski