xmt 360 and poli-seal

E

Ern

New member
Ive been reading for days about the both of them but im lost. I dont know which to get. Does one have more cutting power than the other? Also how often should you use something like this?



Thanks,

Ern
 
From my experience, they're pretty close. I like 360 better because it seems to leave a little slicker finish, and it partically disappears when worked correctly. Poli-seal is good as well. They both seem to remove and hide swirls.
 
In my testing, poli-seal had more cut than 360 (PC and Blue Edge Pad, speed 6). However, I have seen a lot of people who have had great sucess with 360. I don't think you can go wrong with either.
 
The have a very minor polish from what I can tell. I did a dually yesterday and a titan today. It works really well at removing oxidation but didn't really do anything for the swirls on these particular trucks. I like to use the 360 with an orange pad, go over the panel with that and then switch to a white pad and remove any excess residue. It goes alot faster if you will do that.
 
You must log in or register to reply here.
Back
Top