whats the max dillution for SPRAY AND RINSE

joyriide1113

joyriide1113

There is no cure!
I like using Spray and Rinse, only thing is that I find it way too strong, even at 1:1.

Now I'm no Chemist but does dilluting it more than 1:1 neutralize the acids sooo much that it would make the chemicals less effective for weekly washing?

The reason I dont just grab soap and water is because i have my wheels sealed pretty good and Poorboys recommends 1:1 for sealed wheels so that you don't completely remove the sealant. I like just being able to spray the wheels, give a light agitation and pressure rinse the grime off, followed by some mothers fx spray wax to help wipe off any grime and add some protection. I have noticed that using this method extends the life, but still feel that the dillution at 1:1 is still too strong. What if i were to dillute at 1:3 or 1:4?

Thanks again.
 
I normaly go 2:1 but i'm sure yu can go lighter if you wanted to. There is no ACID persay in there it's an Acid salt. which is ""safer"" IE higher p on the PH scale but with the same cleaning power. Anyways Dilution is up to It will not effect the way it cleans just how powerful a clear it is..(IE diluting APC for different jobs)
 
A higher dilution ratio will only reduce the "cleaning power". It will not neutralize the active ingredient(s) in S&R.
 
I tried both way. I use 100% and quickly brush and rinse off.
I think they recommend you do 1:1(50/50).
 
Yea but even at 1:1 its more than enough. I've had my Spray and Rinse gallon for 5 months now and I still have 1/4 left.
 
You must log in or register to reply here.
Back
Top