Whats the Best way to apply NXT using the PC?

K

koko_b_ware

New member
Well, I'm planning on putting a second coat of NXT on my truck in a few days (1st was just 2 days ago) and I've got some questions.



The 1st time I used the NXT, I used a grey finishing pad on the PC and would spread the product at speed 1 then crank it up to speed 4 and spread it evenly.



I don't know what the problem was, but when I tried to remove It with a Micro fibre I had a very hard time getting it off. It was streaking badly and leaving a residue behind.



Whats the best way/speed to apply NXT for the easiest removel?
 
For second coating, I would go with light passes by ghand because the PC might just give the NXT more cleanin power, possibly wiping out your previous layer. Then there's those that say layering is a waste of time. I get nice results with 2nd and sometimes 3rd layers. Streaking? I only got it when I removed too soon cleared up by reapplying
 
I agree, apply NXT by hand but also use it sparingly. You don't need a whole lot of product. Using more will just be harder for you to remove.



Erik
 
You must log in or register to reply here.
Back
Top