What products can be used as a base for AJT when.....

F

Frito Bandito

New member
...you don't have time to wait 30 minutes before removing Prime? I know I've seen it discussed before but can't seem to find any of the threads that mention it. Does it impact the look/durability noticeably to remove Prime and apply AJT after say, 10 minutes? I usually apply Prime with my PC, working it until it's basically clear, then I use AJT to buff off the residue after waiting 30 minutes. The problem is killing those 30 minutes if I'm not also cleaning the interior of the car. :bat
 
Not waiting the full 30mins may affect the "Durability" of Prime since it needs to "CURE."



So by applying AJT too quickly may be removing some of nanotechnology sealant Prime left behind.



And of course, if you use something other than Prime under AJT. I'm sure the different look will be there but it'll be very very subtle. But MOST sealants need a cure time.



Just clean your interior, wheels, engine, or anything else. The interior itself should take 30mins+ which is perfect for Prime to cure.:bigups



- Andy
 
Maybe I work slowly, but if you start at one end of the car (the hood) and apply Prime to all of the car, it takes me more than half an hour. So, once you start the removal process, the Prime would have been curing for over half an hour. No?
 
Well I apply it with a PC and work it until its pretty much clear so it goes fairly quickly and there is little residue to buff off. That's not a bad point, though.
 
I apply my JW AJ on top of Megs Gold Class & it seem to be ok. No problems. And it still have its wet glass look.
 
You must log in or register to reply here.
Back
Top