Ultima Paint Guard - gone bad ?

M

maxshine

New member
I bought the sample kit a couple years ago and decided to try it (being using Optimum Spray). Upon opening box, etc. I noticed what appeared to be a 'hardened line' of product that had formed inside the bottle where it had been lying on its side. (I scraped it with a toothpick)



Is the product still worth using ?



I searched the other day and thought I found posts discussing 'particles' in the solution but I can't find them now.



thanks
 
Ultima has a history of the product jelling in the bottle. The only way to know for sure if it's still good is to try it. I suspect that some of the polymer has activated so it probably won't be as durable but still should work.
 
Same thing happened to my sample kit. I first used a popsicle stick to loosen it up, then mixed it (very) vigorously until it all mixed up again. If you let it sit for a period of time, I find it'll happen again. *Edit, I realize I didn't answer your question. Scientifically, I don't know if it's become much less effective, but I use it anyway, and it still seems to sheet water and add slickness and shine.
 
My bottle is at least a year and a half old and I haven't had problems with clouding or gelling. Two things I do which may help - always make sure the bottle is sealed before storing and don't leave it in a cold place during the winter.



I still have the original trigger sprayer with the little blue cap. I try to put a small vacuum into the bottle before putting the cap on the sprayer to reduce oxygen getting into the bottle. I suppose the ultimate storage solution would be to deaden the atmosphere in the bottle with nitrogen.



I move most of my detailing supplies into the utility area around my basement heater. Sub-freezing temps play havoc with many of the chemicals in our detailing supplies and tends to make components - especially in water/hydrocarbon mixes - separate so I don't leave my stuff in the garage over winter. My guess is the extra heat around the heater keeps the chemicals from gumming up. This is a little counter to accepted knowledge about chemical reactions where heat usually speeds them up.



I can only say this is what I do and I haven't had problems yet. I can't promise you similar results because of sound theory. Note my bottle of UPGP is 2/3's full because I only have two cars which I reseal every 2 or 3 months.
 
I tried what MrRumble did but the particles did not mix back in the solution. So I let them settle and poured the contents(minus particles) to a new bottle, cleaned original bottle, poured back in original bottle and will apply a coat today. If it doesn't seem to apply, cure, etc. properly I'll just toss it. I'm happy with OS.



FYI - the botlle had never been opened - still in wrap, always kept in house. For all I know ity shipped that way. If the product needs continual attention - shaking, etc. This should have been noted in package description.
 
I find it strange that some people have absolutely no problems with this while others have this happen in sealed new bottles stored at room temperature.
 
I applied one coat and it seemed OK. It seems a bit more 'oily' than OS and dried slower. It also seemed to collect more dust.
 
You must log in or register to reply here.
Back
Top