Todays new toy

R

Ray in Kigwood

New member
I went into Northern tool to JUST BUY THIS today



$3 bux......for a male end......thats it.



15935_med.gif




Soooooo



this is what I got to go with it....





I orginially went in for the brass connector you see on top



IMG_6972.jpg




I put the air to this new gal and shet started to move so I held it down...on the concrete it was not a problem...very steady



IMG_6973.jpg




Goes to the full 22 inches in about 4 seconds if you want it to.......swuuuuuuuuuueeeet!.



Got a roll of goo rubber hose so it will reach all the way out to the truck or the tahoe from the garage....



IMG_6971.jpg




I gotta tell ya........this is the most expensive male connector I have ever bought.....



Air powered bottle jack....awesome...and safe



Meets all ANSI, AMSE standards and it appears to be built like a freeekin tank. Fits under the Hoe and the truck just fine......lifts sooooooo ez...



Anyway.......just a jack...thought I would share todays score, and my distinct lack of willpower. They WERE however 10% off all jacks all types nation wide. ;)



:clap:
 
Those air jacks are sweet! We have a few of them here at work and they are THE BOMB DIGGITY!! You'll take all your hand pump bottle jacks to the scrap yard the first time you use that bad boy on somethin!
 
Hmm...interesting! Two of my regular floorjacks are sorta overwhelmed by the DenaliXL and that might be a good solution :think: The pad looks a little small though...any problems you can foresee?
 
chefwong- Heh heh, I'm careful about what I burn up favors on ;)



If I did a 2 x 4 I'd have to cover it with something that wouldn't mar up the frame rails while still being non-slip, easier said than done.



And no, I don't have a chopsaw either ;)
 
You must log in or register to reply here.
Back
Top