Taping a seam?

C

Changeling

New member
When you tape a seam, like between the fender and hood (example) and polish out a section or the whole fender till it is the best you can do. Then you remove the tape, there is going to be an unpolished area where the tape was. Do you finish this thin area along the seam by hand with the same polishing product or what?

Changeling
 
if using a pc no real need to tape down a seam other that to save yourself some clean up...with a rotary its a little trickier but even a seam can still be polished...just takes the right technique not to burn the paint off...otherwise most people i know just leave the seam as is...1/4 inch of unpolished seam is not noticeabe if you taped up evenly
 
and if using a rotory, make sure that the seams are at the same height.. a slight difference in height, which isn't noticed by you , will ruin your day.
 
With an orbital, taping is almost never necessary. With the rotary, I tape any plastic trim pieces, or any protruding parts; such as door handles, washer nozzles, etc. I never tape seams for the exact reason you mentioned.
 
You must log in or register to reply here.
Back
Top