Spring Line up Question on EX and EXP

[GregCavi]

HEllo

I am wondering if you can put a carnauba over EX or would EXP work better? I am unfirmiliar with poorboys products but am ready to order some.

Plan
PB SSR3 (unfirmiliar with the SSR3 will aio clear up any hazing?)
AIO
VM glaze (coats?)
ex or exp? (unfirmiliar with bonding and look?)(how many coats?)
TS x3

I am going the very reflective and wet look. Im sorry for my ignorance i am just new to poorboys.

Thanks in advance

 

[Dr Groove]

GregCavi - I love that combo of VM & EX (I haven't tried EX-P).
Gives a deep, reflective and wet look.

Can you top EX? Certainly can. I have never encountered a bonding issue.
Basically it's your choice what to put on the EX. I love topping with Pin Souveran.

Poorboy's prods are excellent. That company along with CLearKote are my mainstays. I love the fact that you can use on hot or cold surface, in the sun,etc. Another fine product from PB is their tire dressing - Bold N Brite.

Good luck

 

[budman3]

I can't say too much about the other combos, but I have used Ex-P and a little sure goes a long way! Anyways I think you're going to need another polish to clear it up after the SSR3. This definetally is an abrasive product but from the times I have used it, I used some SSR1 to clean it up. Good luck.

 

[GregCavi]

I can't say too much about the other combos, but I have used Ex-P and a little sure goes a long way! Anyways I think you're going to need another polish to clear it up after the SSR3. This definetally is an abrasive product but from the times I have used it, I used some SSR1 to clean it up. Good luck.

to clean up after ssr3 should I use:
megs#9
ht light
ht med

 

[budman3]

I think that #9 should be able to do it. If it doesn't, time to step up to a stronger product. I used the SSR3 to remove some sanding marks. What are you going to use it for? Good luck again!

 

[GregCavi]

I think that #9 should be able to do it. If it doesn't, time to step up to a stronger product. I used the SSR3 to remove some sanding marks. What are you going to use it for? Good luck again!

Im planning on using the ssr3 to remove my cavaliers swirled and scratch paint. The scratches are not down to primer or metal just surface scratch. I went at it will the HT Med Cut and orange pad and was able to remove a decent amount after about 3 passes but it wasnt enough.