Something to add to SIP to work in cold weather?

[Al Buff]

Is there anything you guys add to SIP to make it more workable in cold weather? i add about 2 pea drops of meguiars solo polish and it kinda works but not that good.

 

[elitemobile]

Try Optimum Polish, RMG, or my fav ultrafina

 

[iamwiz82]

I just did a whole car in SIP in temps 25 and below. It came out good, but it took a long, long time to break it down.

 

[imported_rydawg1]

try adding a little UF to it.

 

[Rickrack]

I agree. Ultrafina works great.

 

[maesal]

Have you tried misting some water in the panel to increase the working time?

 

[Al Buff]

I just did a whole car in SIP in temps 25 and below. It came out good, but it took a long, long time to break it down.

huh.. for me, it seems like it has a shorter working time and dust/chalk up right away... even while trying to just spread it.

 

[Brian_Brice]

op works wonders when sip is acting up, just be sure to really really work it down.

 

[raadkins16]

Al Buff, same for me, it disappeared on me instantly in the cold temps... I will have to try the recommendations of mixing and see how it does. Luckily it is supposed to be 60 here tomorrow so I shouldn't have to mix anything to make it work right.

 

[wannafbody]

I find ZPC buffs forever in cold weather-if you have some try adding that. Also, the abrasives in SIP are extremely hard so a long work time will be needed and even then I doubt that they actually fully break down.

 

[iamwiz82]

huh.. for me, it seems like it has a shorter working time and dust/chalk up right away... even while trying to just spread it.

Interesting. Was the SIP also very cold, or was it room temperature? Mine was room-temperature when spread on the cold panels.

 

[Al Buff]

Interesting. Was the SIP also very cold, or was it room temperature? Mine was room-temperature when spread on the cold panels.

huh.. i do leave it in the back of my truck so its probably pretty cold. i might trying putting on the floor of my truck and putting the heater on to warm it up next time. thanks!

 

[raadkins16]

My bottle was warm as it was in my closet, but the panel was cold. I have yet to try a recommendation on putting a halogen on the panel prior to working it to heat it up to a tempurature that would help the polish fully break down and allow for longer working time. I would assume if the polish was cold you could also put a halogen on it for a bit and that would help.