Removing engine bay/underhood scratches

S

Striker

Active member
I've developed a few new underhood scratches on my 99 Trans Am that I would like to take care of. I tried some menz IP with no luck and was wondering what you guys would recommend? I just want them gone and there only on one spot.



I do have a PC with some 4" pads but im not 100% if that will fit in there.
 
Sounds like you might have to work by hand. I'd use M105, probably with some cut-up pieces of an orange pad. Then maybe follow up with the IP and then finish with something more gentle.



No way around it; doing correction in places where the machine can't reach is a PIA. I finally gave up on some spots like that on my Yukon...spent over half an hour on a small area and finally said "good enough" (well, I actually said something very different, but you get the idea ;) ).
 
Crap :( So i'd have to buy an entire bottle of 105 just for this reason. I do have this older compound made by Farcela (yellow bottle) this seems to be more abrasive than my IP......I might see how this works out.
 
You must log in or register to reply here.
Back
Top