Recommend an adhesive?

T

tett

New member
I've got a 98 Crown Vic, and between the headlight and the fender is a strip of black rubber, almost like weather stripping. I would post pics but I can't post them yet because of newbie status. The rubber attaches to the headlight... I guess it is to keep water out of the gap between the headlight and the fender...



Anyway, mine keeps falling out... Is there some kind of adhesive that's good for holding that strip on? I tried just plain silicone, but it didn't hold it.



Thanks.
 
Go to your local painter's supply store (Finish Master?) and get some 3M Universal or Super Fast Adhesive. That molding won't ever come off then.
 
tett said:
I tried just plain silicone, but it didn't hold it.
Click to expand...



did you clean & prep the surface?



did you tape it in place for 24 Hours to set & cure?







silicone should work just fine

it is used in store fronts to hold 100's of pounds of glass in place
 
Thanks for the tips...



Nope, didn't prep at all, so that could be it there... didn't even think about it actually, but it does make sense.



Thanks.



Tett
 
If you use the right product, all you'll need is maybe some adhesion promoter. You won't need to scuff (damage) the surface to make it stick.
 
David you are talking about $40 of 3M stuff. Scuffing what you can't see isn't damage in my book.
 
Any time you're sanding the surface enough to promote adhesion, you're using a pretty abrasive paper (~600 grit). It's really not necessary to go that route & it's not common practice in attaching a piece of trim or molding. Use a General Purpose Adhesive Cleaner to clean the both suraces 1st. Then, either use 2 sided molding tape or a 3M Plastic Emblem & Trim Adhesive. Either one is way less than $5.
 
Thanks gents... I've heard of the 3M adhesives before and even seen my uncle use it when he was putting an interior back in his TR4... so maybe he has some sitting around...



anyway, thanks for all the help.
 
You must log in or register to reply here.
Back
Top