Re-wiring an old PC 7336

I

imported_Picus

New member
Hey guys - so I was digging around and I have 3 (ya) PC 7424/7336s in my basement, one has a dead motor and two just need to be re-wired. I've re-wired my Makita about a billion times, but can't figure out the PC. The cords are pulled out, so I can't just look and re-connect a new cord. Where the wires go isn't super obvious, so if anyone has an internal picture of their PC or knows where I can find info on re-wiring (searched and searched, didn't see anything) I'd appreciate it.
 
You have two wires off the power cord....



DSC_0201.jpg




One will go to the speed dial in back....



DSC_0202.jpg




The other connects to the lower terminal on the on off switch...



DSC_0204.jpg
 
You must log in or register to reply here.
Back
Top