Quickrete epoxy floor

[SubyDude]

Here is what I am having done, even as we speak..........

Ultimate Garage Floors

$3,500.00 for a 3 car garage.

I suppose if you have the money to burn.



I put down the rustoleum last night. I got the 2 1/2 car garage kit from home depot for

$99. Home depot is the only one carying the double kit around here. The Lowes single kits are 62 each. Home Depot FTW!



We'll see how it holds up.

 

[Diehonda]

I read on Garage Journal that you should put baking soda and water down after rinsing the etching off to neutralize the ph on the floor. Anyone done this?



How many coats did you guys use?



New garage floors need the etching. They are too smooth for the epoxy to stick properly.





Our house will be finished in a few weeks and I think I may get some Porter Paints epoxy. Someone on Garage Journal advised that this was the best they offered.

PORTERMASTIC 7000 Surface Tolerant Epoxy

Pot Life: 3 hours @ 77°F

Gloss

Percent Solids:

Weight: 81.5 ± 2%

Volume: 70.0 ± 2%





The weight percentage was much higher than Quickrete or Rustoleom which would allow a thicker and more durable coat. The pot life time is rather fast too. Sounds like professional stuff.

 

[qballjr13]

I have no experience with epoxy floor coatings but I do work in the construction field and if it was my floor I would wait at least 28 days for the concrete to "fully" cure. The truth is that concrete will pretty cure forever, but it is to full strength in 28 days. Depending on the weather the moisture from the concrete can evaporate in days or months. I would think that the heat created from the concrete curing probably wont be good for the epoxy either.

 

[paul34]

I have no experience with epoxy floor coatings but I do work in the construction field and if it was my floor I would wait at least 28 days for the concrete to "fully" cure. The truth is that concrete will pretty cure forever, but it is to full strength in 28 days. Depending on the weather the moisture from the concrete can evaporate in days or months. I would think that the heat created from the concrete curing probably wont be good for the epoxy either.

Yes, this is a must with just about any epoxy coating AFAIK. Must wait at least 26-28 days for cure.

 

[SubyDude]

I read on Garage Journal that you should put baking soda and water down after rinsing the etching off to neutralize the ph on the floor. Anyone done this?



How many coats did you guys use?



New garage floors need the etching. They are too smooth for the epoxy to stick properly.





Our house will be finished in a few weeks and I think I may get some Porter Paints epoxy. Someone on Garage Journal advised that this was the best they offered.

PORTERMASTIC 7000 Surface Tolerant Epoxy

Pot Life: 3 hours @ 77°F

Gloss

Percent Solids:

Weight: 81.5 ± 2%

Volume: 70.0 ± 2%





The weight percentage was much higher than Quickrete or Rustoleom which would allow a thicker and more durable coat. The pot life time is rather fast too. Sounds like professional stuff.

Don't know anything about that product. Not sure about the baking soda either. I bought the rustoleum 2 1/2 garage kit for $99 bucks. Followed the instructions. And everything came out fine. My garage floor was poured about 2 1/2 months ago. It is a slick surface but has plenty of pores. It took just fine. We moved in this past weekend and it help up great to all the traffic. I have not put a car on it yet (mainly because there are too many boxed still ).