Process Help

[Nuke33]

Ok guys I know imp asking a lot of you but I was wondering if you could help me with my process





Wash (GC)



Dry



Clay (If i do this can i do it with car soap or is that dangerous?)



Meg Paint Cleaner Via Pc Finishing pad?? Do i need this step and do i have right pad?



Tape off trim



Optimum polish via light cutting pad



Ex-p via finishing pad (how much longer would it last with 2 coats, is it worth it and is there cure time between) i hear put on 45 min to an hr later buff off then let sit or add wax



collinite Via pc if i can get it out of the tin not sure becasue of the lip



Glass with stoners



Poorboys trim restore on all black trim



Plastex on lights



I have some old meg tire gel that lost its gel ness and i was wondering it it was safe to use on the plastic in my wheel wells



Meg tire gel on tires (New one not same as above)





Thanks

Nuke

 

[Setec Astronomy]

I clay with car was solution all the time. Just make sure the clay is gliding on a film and not dragging dry across the paint. I would tape off before you use any cleaners/polishes (rather than after the Meg's cleaner, by which I presume you mean DC1, which you probably don't need if you are using OP unless you really feel there is a lot of gunk on the paint, OP is pretty solventy and should take off anything that DC1 would).



As far as the EX-P, I think Poorboy recommends a day between layers, but if you are just doing 2 for even coverage, you can do them back to back...although your coverage should be pretty even with the PC. You can get the Collinite out of the tin for the PC by scraping some out with a putty knife, butter knife, etc. I think the old tire gel is worth a try on the wells, what do you have to lose?