problems with Aj trigger

R

roadmaster_Tx1

New member
I recently purchased prime strong and aj trigger, I have no complaints of prime strong, it works real well however I did have a question about trigger. It seems to be streaking too much. I apply it sparingly on my hood, wipe it off with MF towel until its gone. But then when i take it out in the sun, i can see thats its been streaking.



Am i the only one that has had that problem?

Thanks
 
Trust me, I tried everything but it still ends up streaking and leaving marks. I know im probably messing up.

Could it be due to the weather? IT is very humid and close to 100degress here in houston



I was thinknig of switching out from the bottle its in to one of those bottle that sprays a fine mist. :think2







John Styrnol said:
Just do a final buff, and you will be ok.
Click to expand...
 
I haven't had any problems using it, near 100 the last time I used it and relatively low humidity (for Dallas anyway). Just as easy to use as OCW to me.
 
Ya, I'm having problems with the sprayer on AJ:T. It comes out too think and "steak" like. I emailed Jeff and he suggested adding a little distilled water to thin out AJ:T. This may also help with the streaking problem.
 
Normally the streaking can only be observed on the hood, so I suggest you start the application from the hood, than go round the whole car. By then the MF towel is slightly damp with AJT, then you do another application on the hood using the damp MF towel and this will ensure more even coverage reducing the streaking problem. This method works for me :)
 
Gen2 has the answer. You need to ad moister, either a very damp MF or a light mist spray of plain water and then buff dry. Mike
 
Mike-in-WV said:
Gen2 has the answer. You need to ad moister, either a very damp MF or a light mist spray of plain water and then buff dry. Mike
Click to expand...





Thanks for the help guys, Ill have to give that a try next time I use Ajt
 
You must log in or register to reply here.
Back
Top