PoorBoys confusion ??

W

WhosRich

New member
hi everyone, first off i would like to say that i have learned alot from reading this forum and that i am very happy to be a part of it all.



Well my problem is this, i am constructing a shopping cart for my first detail and i decided on poorboy's products. now the thing is, i know i dont need the SSR3 because i dont have deep marring on my paint, but there are a fair amount of swirls. so i figured i need the SSR2 and the SSR1 to finish down. but do i need the SSR2.5? i was reading that i dont need to finish down if i use the SSR2.5 so do i order SSR2 and SSR1 or just the SSR2.5?



Im ordering all my products from Danase w/ the exception of DAS Pads from Autopia car care because EDGE 2k Pads arent compatible with the UDM yet. so props to Danase for the good deals and props to David B. for a successful launch !



Thanks in advance for all of your opinions.
 
My experience exactly agrees with what has already been said.



Go with SSR2.5 for correction and SSR1 to remove marring from 2.5 and leave high gloss. SSR2.5 is much better than SSR2 for removing swirls.
 
Skip the 2 and go to the 2.5...just remember that it leaves something behind, so if you're after perfection, do an IPA wipe after the 2.5 to reveal the true squeaky-clean surface.
 
I have detailed quite a few vehicles and there is yet a correction that I wasn't able to do with just using SSR2.5 and SSR1.
 
WhosRich said:
hi everyone, first off i would like to say that i have learned alot from reading this forum and that i am very happy to be a part of it all.



Well my problem is this, i am constructing a shopping cart for my first detail and i decided on poorboy's products. now the thing is, i know i dont need the SSR3 because i dont have deep marring on my paint, but there are a fair amount of swirls. so i figured i need the SSR2 and the SSR1 to finish down. but do i need the SSR2.5? i was reading that i dont need to finish down if i use the SSR2.5 so do i order SSR2 and SSR1 or just the SSR2.5?



Im ordering all my products from Danase w/ the exception of DAS Pads from Autopia car care because EDGE 2k Pads arent compatible with the UDM yet. so props to Danase for the good deals and props to David B. for a successful launch !



Thanks in advance for all of your opinions.
Click to expand...



If interested, I have an almost full bottle of SSR2.5 that I will sell to you for $13.00 shipped. It's a very nice product and is only missing about an ounce. I'll even toss in a couple samples of some other products for you to use. One is Meguiars hand polish which is great for those imposible to reach places with the PC and also some PB EX-P sealant.
 
You must log in or register to reply here.
Back
Top