polishing an M3-what to use?

P

pampos

New member
Hi it's me again :).i hope you don't get bored by my questions yet..

i am going to detail a black metallic M3 cabrio which is full of holograms caused by rotary polishing and some swirls of course..unfortunately i don't have some pictures to show you..

I know that i have to do the spot test but i would like you to suggest me what to use according your experience..

I am thinking to use menzerna-rd3-02 to remove the damage and menzerna-85rd as a finishing polish.will this do the job or i could handle it by using only menzerna-106fa??

i have also the SFX polishes, Megs #83 and #80, Danase swirl abolisher kit and menzerna menzerna final polish II.I am going to do it by UDM.

Thanks once again :thx
 
Hey pampos



If you have 106fa i would say do your test spot with it and see what you come up with. Otherwise as long as its not destroyed you should make out just fine with 3.02 and either 106 again or 85rd. I have used both SIP and 106ff at the time on a purpleish color with awesome finish via PC



EDIT: and actually I have had great result on an 04 330 of similar color with meguiars 83 and 80. Just had to work them the right way down to finish.
 
getcha said:
Hey pampos



If you have 106fa i would say do your test spot with it and see what you come up with. Otherwise as long as its not destroyed you should make out just fine with 3.02 and either 106 again or 85rd. I have used both SIP and 106ff at the time on a purpleish color with awesome finish via PC

EDIT: and actually I have had great result on an 04 330 of similar color with meguiars 83 and 80. Just had to work them the right way down to finish.
Click to expand...





Thanks.Is it a good idea to use a cutting pad or it is better to use only polishing pads??
 
You must log in or register to reply here.
Back
Top