PB and GEPC, where does it fit in (gotta use it up)

P

prgallo

New member
I have some GEPC to use up, I'll be doing a red car and a black car over the next couple of weekends and would like to work it into my PB products.

In total I have SSR2 I'll be using w/a cutting pad (on a PC, they both need it), after that I'm up in the air, here's what I have on hand:

SSR1, PWC, GEPC, polishing & finishing pads.

I probably have enough GEPC do do one car, the other I plan to do:

SSR2
SSR1
PWC

Suggestions on the other? (I'm guessing GEPC could be used in place of SSR1, but not sure, is there an advantage to using both?)
 
SSR2 for high defect removal. Follow with GEPC then just pick up some S100 Wax.

If not, slight defect removal SSR 1 to GEPC

GEPC is sorta like a glaze, so I don't think you can run PwC after. Maybe you should use GEPC for a very well kept car. Use S100 though.
 
You must log in or register to reply here.
Back
Top