I have some areas on my Civic I'd like to do by hand (decent marring) and am not sure how I should go about it. I have the following:
SIP
106FF
OC
OHC
1Z EPC
4k Mirka wetsand
I was thinking maybe the 4k then 106ff? I tried doing a part by hand using SIP on an orange Edge 2k (light cut pad I believe) then 106FF on the same one and it helped a bit but didn't remove all of the marring. If the 4k can achieve the same cut as the SIP with much less arm abuse I'd be all for it, I could deal with finishing up with 106FF by hand. Maybe OC then 106?
I should also mention I have white, green, orange, and yellow Edge 2k and white, orange, and yellow LC.
Perhaps it is time to get some UF.
SIP
106FF
OC
OHC
1Z EPC
4k Mirka wetsand
I was thinking maybe the 4k then 106ff? I tried doing a part by hand using SIP on an orange Edge 2k (light cut pad I believe) then 106FF on the same one and it helped a bit but didn't remove all of the marring. If the 4k can achieve the same cut as the SIP with much less arm abuse I'd be all for it, I could deal with finishing up with 106FF by hand. Maybe OC then 106?
I should also mention I have white, green, orange, and yellow Edge 2k and white, orange, and yellow LC.
Perhaps it is time to get some UF.