Operation Clear View

zckid

New member
Hi folks

Been inactive for long,

Anyway, presenting to you 2 cases in one:

1. Persisting with wiper blades that are long past their prime

2. Using amateur techniques to remedy damage caused by bad wiper blades that have actually worsened the driver`s line of vision


Torn wiper blades or wipers missing the rubber blade edge can often leave deep scratches along with streaks on your windshield. These scratches will be just as distracting as streaks. They will reflect sunlight and headlight beams from oncoming traffic. Scratches will definitely obstruct vision, making driving more dangerous. However, it is important to remember that damage can occur any time a repair is not done correctly, making vision still more obstructed.

Letting the pics speak:


Front glass: water spotting and swirls

001.jpg



water spots removal gone from bad to worse

001a.jpg



swirled glass

003.jpg




close-up of damage caused

002.jpg



can u see through?

003.jpg



The result of using inappropriate products, tools and techniques to remove wiper scratches

004.jpg


005.jpg


006.jpg




From inside.....clarity or a lack of?

007.jpg




closer

009.jpg




Worse still, during a rainy day or night when facing headlight beams from oncoming vehicles

010.jpg



Close-up: wiper scratches have been left intact while new scratches have been instilled

011.jpg


013.jpg


012.jpg




Rear glass: heavy water spotting from acid rain/ wrong maintenance

015.jpg



Close-up

016.jpg



TA DA

017.jpg



Sealing the whole work

018.jpg



Sealing for a wiper free drive

019.jpg




Wiping after curing, we`re grateful to Almighty, all scratches gone and clarity restored

020.jpg


021.jpg



Mirror, Mirror! Where are the water spots

023.jpg



Can you see through?

022.jpg


0001.jpg



Thanks for viewing. Your thoughts and questions are most welcome

Zaid
 
What are the products and pads used?

Sent from my SM-G955U using Tapatalk

Tools & Products

- local APC & towels
- Sonax clay
- Sonax felt pad
- Sonax glass polish
- Makita rotary
- A spray bottle with water
- Menzerna Powerlock sealant and applicator

Process

- wash and clay the glass
- tape all rubber trims and cover adjacent areas
- mist the felt pad with water
- apply the polish to a small section of the glass
- proceed slowly to prevent heat build-up. every now and then, spray water on the surface being polished
- check your work at all times, it may require quite a few hits
- be patient and check the temp regularly
- clean and apply a sealant, let cure and wipe

hope it helps and with this, i complete my 200th post.

cheers
 
Back
Top