Ok, still can't figure it out...

E

ExplorerXLT95

New member
I still, after all this time as an Autopian, am a bit unsure about the before and after steps of a polish such as 3M SMR, DACP or Menzerna FPII. Mainly, I think it's because I have yet to need either of them badly, and as such have never really used them. I guess because I've always used good products and kept my cars in good condition, especially paint-wise. I've played a bit with 3M SMR by PC on my dad's car, but very little.



So basically, here's my question:



After using a polish such as 3M SMR, DACP, or Menzerna FPII, what is the appropriate next step/product??



In the very, very limited experimentation with polishes on my dad's beater, I found that after using 3M SMR by PC, there was a noticeable loss of gloss in the area I applied it. After applying AIO and SG, it returned, but I'm wondering if there should have been a step to restore gloss immediately after the 3M SMR. That is the main source of my question.



Thanks in advance ladies and gents :xyxthumbs
 
The next step would be to use a final polish such as: PBs SSR1, VM, PBs PP to name a few. If I'm wrong please let me know.
 
I think the Menzerna IP would be comparable to DACP. FPII is close to SSR1 and VM. I have heard where DACP and 3M PI III have not needed a next-step polish, but I would think that another step would not be out of the question.
 
Exaclty what everyone has said. The next step is a polish, a mild abrasive.



It goes like this:



Swirl remover (removes swirls, but it's abrasive, removes gloss)

Polish (mild abrasive, restores gloss)

wax (no abrasive - protects finish)



AIO is one of the polishes, so you were correct in your steps. You did SMR (swirl remover) AIO (polish) SG (wax/sealant)



My favorite combo goes like this:



3M fine cut with PC and cutting pad (cutting pad + fine cut = abrasive swirl remover)

AIO with PC and polishing pad (AIO + mild, smooth polishing pad = super shiny)

Gliptone platinium with PC and waxing pad (wax + waxing pad = perfect shiny happy protected finish)



So yeah. You're fine. You're doing it right...
 
blackntan said:
Exaclty what everyone has said. The next step is a polish, a mild abrasive.



It goes like this:



Swirl remover (removes swirls, but it's abrasive, removes gloss)

Polish (mild abrasive, restores gloss)

wax (no abrasive - protects finish)



AIO is one of the polishes, so you were correct in your steps. You did SMR (swirl remover) AIO (polish) SG (wax/sealant)



My favorite combo goes like this:



3M fine cut with PC and cutting pad (cutting pad + fine cut = abrasive swirl remover)

AIO with PC and polishing pad (AIO + mild, smooth polishing pad = super shiny)

Gliptone platinium with PC and waxing pad (wax + waxing pad = perfect shiny happy protected finish)



So yeah. You're fine. You're doing it right...
Click to expand...



Sweet, so I was doing it right all along. Thanks a bunch :xyxthumbs
 
You must log in or register to reply here.
Back
Top