Newbie question about PC's

S

Sinister04L

New member
I'm getting another car next month that's black and has quite a bit of swirling. The paint appears to be in pretty good shape except for the swirls (always garage kept). I picked up a PC 7336, some LC pads (orange, white, blue), and I'm going to use SSR 2.5, SSR1, VM, and CMW and I had a couple of questions. Should I use the PC to remove the product after it's applied or should I remove it by hand? If I use the PC, what type of pad/bonnet should I use? Thanks in advance for any advice you can give me.
 
I have never used the PC to remove any product. I always use MF towels instead.

For PC product removal, you just need to get a MF bonnet and put it over a clean pad. Go over the product with very light pressure to pick up the leftover product off of the paint.
 
Ive never removed anything with the PC either. From what we read here, its not a very worthy tool for the job.
 
I've used my MF bonnets to remove products before. You can also use a *very* soft finishing pad to remove product as well.



That said, I prefer removing it by hand. If a product is being difficult to remove, just use some QD.
 
You must log in or register to reply here.
Back
Top