Need some suggestions...

T

tim0shel

New member
I have Red and Black vehicles. Im wanting a good product or products for them both but like a whole correction to finishing setup.

Now i have some werkstat prime strong and acrylic jett trigger

so what should i use before or after this product?

In the past Ive used mothers 3 step process but i think im wanting to take it further and get more into it now i have found this site. Right now i do have a cheap orbital but no rotary tool YET!!

I will post some pics of what im working with on my truck.
 
Ok the pics, the spots are dust mostly.

IMG_4673.jpg


IMG_4671.jpg


IMG_4670.jpg


IMG_4668.jpg


IMG_4650.jpg


IMG_4649.jpg
 
for getting those swirls out, I would suggest a Flex dual action (3404) polisher. A good spread of different polishing/finishing pads and at least polishes. A good cutting polish and a finishing polish. A good stack of quality microfiber towels will also be needed.

If you're experienced with a rotary, then you can go that route but the flex is supposed to be perfect for in between regular DA's and rotary.



Menzerna offers arguably the best polishes on the market. Many will suggest these but plenty others will be effective as it's YOU that will ultimately determine the final outcome.



Pick up a nice paste wax too!
 
A PC will do the job and is cheaper than the flex. Four inch pads on the PC will correct most defects, it takes a while but you do not have to stress about burning the paint. I have had good luck using the Zaino Swirl and Scratch remover with an orange pad followed up with a green pad on my black Mustang. Got more than a few trophies using this combo topped by Z-2 then Danase Wet Glaze. Works well for me but there are numerous combos that have worked. I am just a Zaino and Danase fan. All great products from both.
 
You must log in or register to reply here.
Back
Top