Need help with OCW

Sorry for not responding guys. I do thank you each of your opinions. Been busy lately with work. Anyways, the results are completely stunning with less effort. This was like adding a glaze to the car it's that wet!



Back to the topic. So yeah, like I said I only use tiny spritz max is 2 tiny spritz. What I mean is I would lightly tap the sprayer once or twice on each panel. And if I don't wipe them fast enough. The streaks would dry dead on the paint. If I give it another spritz to clear it up, it still doesn't help. I even tried using OID which didn't help either. The streaks gets dried and stuck there. So I got another QD which is the Meguiar's Final Inspection. That kinda worked a little bit.



As for prep, I washed the car at coin operated. Dry. Next day used OID to remove light dust. Then used KAIO to remove the water spots (it's been raining for weeks over here). Then used Meguiar's Final Inspection to remove the KAIO. Then used OCW. I'm going to try the OCW this week again and see what happen. From what I read you guys said I'm using too much. This time I'll use it differently. I'll use less than before and see if the streaks would dry on the paint again.
 
I had streaking until I switched to 2 microfibers - one to apply and one right behind it to buff. I tend to apply if fairly well too. Since switching to that method - no streaks at all and much less effort.



Try 2 cloths.
 
dschur said:
I had streaking until I switched to 2 microfibers - one to apply and one right behind it to buff. I tend to apply if fairly well too. Since switching to that method - no streaks at all and much less effort.



Try 2 cloths.



that is what i do =D



and i use a finer woven microfiber for the buffing part but i am sure any two will work just fine
 
GS4_Fiend said:
Then used KAIO to remove the water spots (it's been raining for weeks over here). Then used Meguiar's Final Inspection to remove the KAIO. Then used OCW. I'm going to try the OCW this week again and see what happen. From what I read you guys said I'm using too much. This time I'll use it differently. I'll use less than before and see if the streaks would dry on the paint again.



Do you get streaking if you don't use KAIO or Final Inspection?
 
Back
Top