Mytee HP60 - Need A Little Help

MattS

MattS

Oh no, another engineer!
Guys,

I have a Mytee HP60 and the upholstery wand leaks after I release the spray handle. It will continue to drip about 1-2 drops per second. Any one else had this problem and more importantly, got a solution to fix it? Hard to get the upholstery clean and extracted with the dang thing dripping when I ty to extract. BTW, I have crevice and an S bend floor wand which work just fine with no issues.

Thanks in advance!

-Matt
 
I second that. You payed good money for it...........they should help you out. I have had mine for only a month with no problems.
 
Guys,

I have sent an email of to Mytee as well as the vendor I bought the unit from. The vendor replied immediately with very good customer service. He made a few suggestions to replace the 4 o-rings in the upholstery tool. He offered to replace the tool straight up, 9 months after the sale and I offered to attempt to fix and only return if I was not able to fix it on my side here. Very good customer service from my sales vendor, no response from Mytee and I am not holding out for one.

Thanks for your replies and I will keep you updated on the response I get from Mytee and if the o-rings being replaced solve the drips!

-Matt
 
I had this happen and found out what the problem is. I took the entire sprayer apart to find the leak. Mine was leaking at the yellow tip. You will find that next to the yellow tip are 2 screws. First, try tightening those screw and see if that works. If not, unscrew them. You will find a small black rubber o-ring. Inspect is to make sure that it has not been comprimised. If it has, called Mytee or sparkle auto for a replacement. Let me know if this helps.
 
I went to my local DALCO store and they were able to fix the problem but had to order parts. Thanks
 
You must log in or register to reply here.
Back
Top