Megs #9 - What to apply with/remove?

PC - polishing or light cutting pad - work on the higher speeds until it starts to remove itself - remove with MF towel imediatly

Hand - Foam or MF applicator - work product in until it actually starts to remove when you are buffing - remove with MF imediatly

Please somebody correct me if I'm wrong.

Greg
 
For PC use, I'd go with a polishing pad at speed 4.5. For hand use, try a cotton terry covered applicator to provide a little "bite". In either case, remove with a densely woven microfiber towel with medium pile height. Work on one or two panels at a time.
 
I always have a hard time working with #9. I thought you were suppost to try and work it until it is almost dry. But when I try this it always totally dries on me.

I also never seem to get the results I'm looking for. Probably because I don't know how to use that product?

So just keep working it until it removes itself? I will have to try that.
 
zannard said:
I always have a hard time working with #9. I thought you were suppost to try and work it until it is almost dry. But when I try this it always totally dries on me.

I also never seem to get the results I'm looking for. Probably because I don't know how to use that product?

So just keep working it until it removes itself? I will have to try that.
Click to expand...
9 is a chemical cleaner.....if you have issues removing, you may be using too much, give a little QD spritz and wipe with MF.....
 
You must log in or register to reply here.
Back
Top