Klasse Sealant Glaze

jvn,

Szívesen!

BTW, I don't know the correct pronunciation of Häagen-Dazs. :D WTF words are these?! :dunno

:)
 
I would use a dry applicator with sealants. The cross linking of the polymers is stopped when water is introduced on top of the protectant. It is arguable that the surface should not see any water for 24 hours because of this.
 
Mark: 10:1 water to SG is a rough estimate, I wasnt very scientific about it. I figured that SG was a water based acrilic sealant so a little extra in application couldnt hurt. I put this to the Australian distributor and he didnt think it would do any harm to durabily of the product. If you would like to make the mixture stronger then give it a try. This system has worked extremly well and easy for me so if you have problems with HGSG before in terms of hasing, streaking (normally due to not leaving the product on long enough before removal if not using the wipe on/wipe off method) or removing then this is an excuse to give it another try.

Corey: Not 100% on this but i think the instructions/recomendations are not to wash the vehicle ie. with car wash during this curing process. If I am wrong I appologise in advance

tony.
 
Mizzuri, well, I'm not sure about mixing it in. You may want to try doing a test panel, cut in half, to see if it really affects durability at all (or in any way that matters). I don't have much SG to try this with or I would.
 
You must log in or register to reply here.
Back
Top