Just not sure where to start with this one

[Tarios]

marring is very very small scratches, usually left behind by strong compounds. They could be very hard to see (especially on white) you could use a magnifying glass and halogen light to see this. Sometimes it's visible by eye and appears as haze, or a dull surface.

If you have marring, I would try propolish or SSR1 on a polishing pad.

I have used 2.5 w/orange followed with PwC w/polishing pad with good results on my white acura.

I have also used 2.5/orange followed by ssr1, with two coats ex with good results.

I have also used 2.5/polishing pad followed by PP polishing pad, then K-SG.


First inspect your finish, then use appropriate polish and pad. Do test section before going over the entire car! this could save you steps, not to mention give you better results.

hope this helps.

Thanks for the tip..
My last step was SSR1 with with white pad.
Surface looks godo and feels very smoothe.
I think I ll do another pass with PB PP and with polish pad before beginning my Zaino steps..

 

[cheapshot]

The SSR1 should have left it ready for zaino, But if you feel the need to clean up some marring or haze, use PP/polishing pad, If you want to just clean the paint to perfection you could use a finishing.


I used an entire bottle of PP on my white car, over the years. It's a great cleaner, and keeps white "White" leaving it ready for sealant or wax.

 

[Tarios]

The SSR1 should have left it ready for zaino, But if you feel the need to clean up some marring or haze, use PP/polishing pad, If you want to just clean the paint to perfection you could use a finishing.


I used an entire bottle of PP on my white car, over the years. It's a great cleaner, and keeps white "White" leaving it ready for sealant or wax.

You couldn`t be more right..
The SSR1 had left such a great finish that when I did a test spot with the M205 and Pro Polish..I realized how good a finish SSR1 had left - not as clean as the M205 or PP..but very very smoothe.

M205 left the next best finish as far as cleanl feel and smootheness and Pro Polish was third in the line up..PP did leave a cleaner feeling touch but not too smoothe.
I decided to go all around with the M205 and the brightness is a tad more clear than that left by SSR1..but like I said the SSR1 was silky smoothe.
So do you think I should go back to SSR1 before Zaino begins..and go straight from M205 with the Dawn wash and go to Zaino.

With Zaino I will beginning with AIO step...