how to maintain the pc?
- Thread starter quamen
- Start date
nailzer
New member
From my quite limited experience, and I'm not a pro detailer, the first thing I would do is make sure you have the correct counter weight for the size pad you use. That alone could extend the life of your PC.
Accumulator
Well-known member
I don't maintain mine at all 
I just use 'em until the bearings start to rattle and then have them serviced. They usually last many years before this becomes necessary.
The manual says to "blow out all air passages with dry compressed air" but IMO that applies more to its being used as a sander.
The manual also says "your machine is lubricated with sufficient lubricant to last for approximately one year's operation time. To add lubricant it is necessary to dismantle the tool. This operation should always be handled by the nearest PC authorized service center..."
Three years of non-commercial use doesn't sound too bad for most PCs. You should be OK.
I just use 'em until the bearings start to rattle and then have them serviced. They usually last many years before this becomes necessary.The manual says to "blow out all air passages with dry compressed air" but IMO that applies more to its being used as a sander.
The manual also says "your machine is lubricated with sufficient lubricant to last for approximately one year's operation time. To add lubricant it is necessary to dismantle the tool. This operation should always be handled by the nearest PC authorized service center..."
Three years of non-commercial use doesn't sound too bad for most PCs. You should be OK.