Hi, I recently purchased a PC7336 and I did my whole entire black car. I used SMR to get out a few of the swirls.I think they were medium to heavy swirls. After, I AIOx2 and SGx2. I think that my paint looks beautiful now, but when I am in direct sunlight and I inspect very closely, I still see a few light micro swirls. Is this normal? or was I expecting too much. Again, I am very pleased with the results and I would like to thank everyone for contributing and making this all possible. Thanks.
High expectations?
- Thread starter mDw
- Start date
If there are still light swirls, either your buffing method put them there or just didn't take all the old ones out completely.
Next time you decide to go after them, make your last pass with a swirl remover by hand, working in a straight line (as air flows over your car) and until the product is nearly clear and dry. Buff off and then go back over with a real light glaze (like 3Ms Imperial Hand Glaze or Meguiars Show Car Glaze) by hand and prior to waxing.
That is what I did on this Suburban:
Next time you decide to go after them, make your last pass with a swirl remover by hand, working in a straight line (as air flows over your car) and until the product is nearly clear and dry. Buff off and then go back over with a real light glaze (like 3Ms Imperial Hand Glaze or Meguiars Show Car Glaze) by hand and prior to waxing.
That is what I did on this Suburban: