MarkD
New member
Yes, I know, this did appear like a one off unusual set of circumstaces that I encountered with the C4 product.
I did follow explicit application instructions with the product, in that I did do a thorough cleaning with an APC, then onto an Alcohol wipe down to get this particular plastic piece as pristine clean as possible before C4 Application.
I was told by other members, and was also contacted by someone from GTechniq, a possibility of over-application (determined by how much product I actually used to coat this particular piece) but there was never an offer of re-imbursement.
I wouldn't have thought such a product would be that sensitive to a possible over-application, and one quality I noted about C4, and somewhat similar in properties to CQuartz DLX, the product cannot be monkeyed with while curing as the product then gets a tacky feel, and will only smear at this drying phase.
When I did acquire the brand new Step Pad, and installed, it was treated to a coating of CQuartz DLX immediately, and this product has worked admirably well on this part, as well as all other Plastic Trim Pieces everywhere else on the outside of vehicle mentioned. Even the Windshield Wiper Cowl was removed, cleaned and treated with DLX, and the differences were not at all subtle.
Perhaps my own fault that I never personally contacted AG, and communicated, or pressed them over the possible issue of a refund-credit for this particular product. That I know AG commonly does back all it sells with an iron-clad satisfaction guarantee.
Mark
