Extreme Make over on a Mazda 3

99blackse - It is not very often that we get to work on an orange peel free car and the end result is very satisfying.
 
Gen2 - beautiful work and amazing results. I'm still getting used to rotary speeds for initial cut down and am curious what speed you used with the IP initial cut down. I've been experimenting with speeds in excess of 1500 (though not much more than 1700) for more severe cases and will work a panel over 2-3 times to get the level down enough to lighten up the final buff out needed from there. Your results are absolutely fantastic and I like learning from the guys who can do it like that!
 
Puckman - Thanks for the compliment. I usually work with a speed of 1400 rpm with IP but the trick that works for me is to move the buffer slow and also strictly work on a 2'x2' area.
 
You must log in or register to reply here.
Back
Top