Ex-P Application Question

W

WrxRob513

New member
What is the best way to apply PB's EX-P sealant? By PC polishing pad or by MF applicator (hand)? I have never used a PBs sealant before and was looking for advice. I have always had good luck doing SG with the applicators and buffing off the MF.



It will probably go on top of AIO after SSR 1 and 2.5 if needed.



I am detailing a red VW and a black Porsche this weekend and think that I will seal with SG on the red and EX-P on the black. Sound good?



Thanks,

Rob
 
I find it quicker to put on by hand as the PC spreads it so thin I can't see where I've put it, so end up going over the same area time and time again. But that's probably just me being stupid!:D



Ben
 
CamV6 said:
and whilst we are on the subject, should it be applied in straight lines or swirls?
Click to expand...



I play it safe and apply via lines. IIRC Swirls are (almost) always :nono 'd during application. YMMV
 
CamV6 said:
Straight lines back and forth or in one direction only?
Click to expand...
When I've used EX-P, I've put it on going back and forth in both directions, using hand or PC application with no problem.
 
You must log in or register to reply here.
Back
Top