Cyclo polisher switch

C

Corey Bit Spank

Active member
Hello everyone! I pulled out my Cyclo from winter storage today and found the power switch broken. Basically, the switch can be pushed into the handle of polisher itself (along with the threaded base). I was wonder if anybody knew how this could have happened, or provide a picture of a close-up of their Cyclo so I can figure out how to fix it best. I might just put on a nut around the outside to prevent the switch from falling in.



Thanks!
 
Hi Corey! Howzit going? There's a really thin jam nut that holds that switch in place from the outside. I'm guessing it's going to be tough to find locally--I'd give calling Cyclo a shot, they are supposed to be really nice, and that nut is thin enough that they could mail it to you in a regular envelope (taped to a couple pieces of paper to keep it from getting jammed).
 
You must log in or register to reply here.
Back
Top