Clearkote VM via rotory anyone?

joyriide1113

joyriide1113

There is no cure!
I have finally begun feeling CONFIDENT with the rotory, I wanna do everything with the rotory. I've must of double my deltoid size, because I have no soreness anymore and my muscular endurance of holding the machine vertically has doubled. Anyway, Besides using the machine to polish out swirls, I've begun using it to apply waxes, sealants, glazes, ect at low speeds.

What do you guys think of using VM via rotory. I know it cleans good, and has a slight cutting ability. I would use it with a finishing pad, which is what has been my go to polishing pad for removal of wash induced marring to the vehicles I maintain, but do you guys think VM will cut it? Excuse the PUN.

Joy
 
I've used VM on the rotary before with a finishing pad. It works fine for light marring.

It's a bit too watery to lay down a bead for 'pick up', which I don't particularly like. These days I only use a D/A machine with VM (PC or cyclo) for this reason.
 
usually I get a lot of sling, but minus that it works great so far, removes wash- induced marring.
 
use it with a finishing pad @1200, You migth aslo like to spray it on to work it in?

Greg
 
Do it all the time - 600-1200 rpm, up and down, side to side
Really easy, I might try the spray

Doesn't have cutting ability, takes a fraction of paint off. I always follow with at least RMG if not Yellow as well with LC black and edge white
 
You must log in or register to reply here.
Back
Top