Cleaning MF Pads On The Fly???

[pwaug]

Don't have access to an air compressor so I clean foam pads on the fly with a towel and denture brush--works great, but I'm going to pick up a few Optimum MF Cutting pads and was wondering can I clean them effectively on the fly using the brush and/or towel without damaging the MF pads???

 

[Thomas Dekany]

Depending on where you order it from, you get a brush with it. Works very well, not damaging to the pads. Use it

 

[tonipieleanu]

I use a Meguiars Triple Duty brush. Works like a charm.

 

[imported_RZJZA80]

I use the Megs pad conditioning brush, might be called triple duty, not sure, but it works fine if you don't have a compressor handy.

 

[pwaug]

Thanks for your replys!! Do you brush the MF with the pad rotating or stationary?

 

[imported_RZJZA80]

turn the machine on to use the brush

 

[Thomas Dekany]

Thanks for your replys!! Do you brush the MF with the pad rotating or stationary?

I use it in the off mode - holding the plate from the bottom

 

[Accumulator]

I know this will be an unpopular reply, but here I go anyhow:



Buy a cheap compressor. I bet even the $39.95 one at Harbor Freight would work OK. I consider a compressor to be pretty much an indispensable tool anyhow.



OK, OK...sorry

 

[Thomas Dekany]

I agree, but just to clean the pad, the brush that comes with them works fast enough and good enough.

I know this will be an unpopular reply, but here I go anyhow:



Buy a cheap compressor. I bet even the $39.95 one at Harbor Freight would work OK. I consider a compressor to be pretty much an indispensable tool anyhow.



OK, OK...sorry