Clean pad before changing compounds

A

anubus12

New member
This may be a really stupid question, but if I wanted to try a few different products and don't have more than one of any colored pads, should I or do I need to wash throroughly it and let dry before putting on a different product?



I know I have to buy more pads, but I wanted to try a few different products quickly with what I have.



Thanks for any inputs.
 
Do you "have to" or "should you" might be a better question. You should try to get off as much of the previous product before changing to another product. For example, if you went from an agressive cut to a mild cut, it is a good idea to remove as much of the agressive polish as you can to ensure that the finer polish isnt contaminated.



If you want to try a couple of different products on the same pad?? I say go for it. I know that is what I did when I only had one pad and wanted to try out some different stuff.
 
I'm probably way off base here, but here's what I do...



When I'm trying to figure out what polish to use, I grab the color pad i think is appropriate, then do an application of the polish. If it's not what I want and I want to try a different product, I use a nylon brush on the pad, apply the next product, and have at it again. I keep doing this til i find the product that's giving me the results I want. At that point, I grab a new clean pad and have at it.
 
i do what superbee364 does...works fine. i would only be very careful when going down from a stronger polish to a lighter one...but stepping up in strength won't harm much w/out washing inbetween.
 
You must log in or register to reply here.
Back
Top