AJ (acrylic jett) a good choice over Poorboy's SSR polish line?

[ssgohan434]

I already have an almost completely full SSR polish line containing SSR1 , 2, and 2.5. Im out of the Meguiars NXT tech wax ive been using before to top these polishes off and was wondering if AJ would be a good choice on top of SSR? Any other recommendations?

Thanks.

 

[natebood]

Polishes don't remain on the car as a layer, so anything should do regardless of what polish you used.

 

[gmblack3]

For best results you will want prime before AJ or trigger.

 

[SpoiledMan]

Polishes don't remain on the car as a layer, so anything should do regardless of what polish you used.

While you do wipe them away there is often residue or polishing oils that remain on the surface that will interfere with some sealant products. I'd say that for ease of use and likely durability as well that it's best to at least do a 50:50 wipe down.

 

[Wasatch]

Go with Prime before AJ. To remove marring before the Prime the SSR should be ok.

 

[MrSelfDestruct]

While you do wipe them away there is often residue or polishing oils that remain on the surface that will interfere with some sealant products. I'd say that for ease of use and likely durability as well that it's best to at least do a 50:50 wipe down.

:werd: I like to give it a quick wipe with a wet chamois and dry after polish. Sometimes I'll even give the car another gentle wash if I've polished the whole thing.

 

[imported_hooked]

Go with Prime before AJ. To remove marring before the Prime the SSR should be ok.

My daily driver (don't have any other) car has light marring (spider webs?). I was considering getting Prime Strong to address this and clean the paint. Will it PS work to reduce the marring or does it just fill it or both?

 

[Wasatch]

As far as I know it will remove, but you will need a PC.