acetone on aluminum?

K

Ktulu

New member
I did a search and came up with acetone being used on emblems and whatnot, but not aluminum. I understand this stuff is really friggen strong and want to make sure before using. Actually, I'm not using it, but thats besides the point. Its being used to strip the clearcoat off of a wheel. The autopia guide calls for a "aircraft grade stripper" for this job. Is that basically what acetone is?



Thanks
 
Acetone is not Aircraft paint remover, and it's dangerous to work with. You can go to a body paint supply store and ask for a Aircraft Paint Remover, most stock it.
 
Acetone is not that strong. Nail polish remover is usually a diluted acetone solution. In it's pure form its a bit stronger, and tends to dry out the hands, so use rubber gloves. If you need something a little stronger try denatured alcohal, and then after than paint thinner...........



Hope this helps.....
 
Acetone isn't a good choice for stripping the clearcoat off aluminum. While it won't damage aluminum, it's not thick enough to remain in place to soften the coating.



I'd suggest using a proper stripper. In addition to the aircraft stripper mentioned, Busch Enterprises, Charlotte NC makes a product called "Clear Coat Remover", part # 64016. It requires the use of rubber gloves and proper eye protection, but is very effective.



The last phone # I had for them was 704 588-2067.
 
Acetone isn't that dangerous with the exception of flammability. As a chemistry major we used the stuff to clean anything. But it is not a good high strength solvent for paint. Plus it evaporates quickly and is very thin, so it won't sit on the spot you are trying to clean.



As for drying out your hands, Acetone is great for taking wet glassware and drying it. The acetone hydrogen-bonds with the water and as it evaporates, takes the water away with it.
 
You must log in or register to reply here.
Back
Top