#80 question....

I

Intense2jz

New member
How much speedglaze should i apply to the pc pad?? also i dabbed the pad around the section i was going to work and then started on 2 to load the pad and spread the speedglaze evenly on the work area. Then i bumped it up to 4 and worked it until it was almost dry and clear. Is this the correct way to do it? Any help would be appreciated. Thanks.



also any tips on using dacp would help too.
 
Not bad! I prefer three total passes, 1. up/down, 2. Side/Side, 3. Up/down.....I like to load the pad at 12, 3, 6, 9 o'clock positions, then smear it on the panel im doing, kind of spread it around while the machine is still off. Then i make passes at 4, 5, and final pass at 6.......I use the same for DACP, although #80 is less abrasive, its a heck of a lot more user friendly......and can get you out of most jambs....
 
I tried #16 over #80 on red and was quite happy with the results.But that's in my eye's and everyone here will have a combo that's there favorite.;)
 
You must log in or register to reply here.
Back
Top