5" plate for a rotary..Where..

AL-53

AL-53

Duragloss User
I have been looking for a 5 or 5.5 plate for a rotary and have not found one yet..does any one know who has them....I have seen 3.75 and then jumps to 6"..I cut a 7 down to a 5 but it is getting old.. need a new one...



Thanks



AL
 
Thanks...I will look them over...you would think they would be more common on sites so you could use your 6" pads with both the PC and rotary....



Al
 
ZoranC said:
I got wonderfull 5" rotary backing plate from Kevin at Kleen Car.
Click to expand...



got a web address...I have seen different variations and would like to see more...some are flexible..some ridgid...sometimes its that special one that grabs you and you say thats the one....I was looking for a foam cored one that is flexible...but they may not make one..sorta like some of the PC plates with foam center



AL
 
Thanks guys..I ordered a plate ..actually a 4.75 as I ordered a bunch of CCS pads from Danase (5.25) and and I believe the plate will work fine with my 6" pads also...



Spring is around the corner and my truck took a heavy toll from winter....



Next is my Menzerna order from Europe....



AL
 
It was a LC flex pad....Yellow urethane construction....I have a ridgid bodied one I machined down from a 7 inch pad to a 5 inch...wanted one with flex this time...



Again Thanks all



Al
 
You must log in or register to reply here.
Back
Top