dafowl1
Stick to the details
man look at those wheel wells
03' Ford Explorer Detail - NEW CAMERA!!
- Thread starter GregCavi
- Start date
mingraygt
New member
That looks a crap load beter! Good job.
Ryan
Ryan
Greg:
Nice Job!
I have the same camera and I like it a lot.
Unfortunately I don't use it enough and have not used all the features.
I just basically use it on automatic.
I am also computer DUMMY and don't know how to post pictures to the forum.
Need some advise on that topic.
I must say I am pretty good at car detailing though." IMHO of course"
Schroeder
Mendota Heights, MN.
Nice Job!
I have the same camera and I like it a lot.
Unfortunately I don't use it enough and have not used all the features.
I just basically use it on automatic.
I am also computer DUMMY and don't know how to post pictures to the forum.
Need some advise on that topic.
I must say I am pretty good at car detailing though." IMHO of course"
Schroeder
Mendota Heights, MN.
GregCavi
Pinnacle Detailing Owner
Thanks for the comments everyone!!
Greg
Greg
sneek
New member
You just reminded me how much i was hyper dressing!
Amazing job!!
Amazing job!!
hemin8r
ShineTech Auto Detail
That truck was a mess. Nice job. End results are awesome.
justin30513
Mobile Detailing Services
Nice job man!
I'm a huge wheel-well-must-be-clean-as-heck man and those are clean!
See that duffel....been to ADS lately? I order about 90% of my stuff from there.
Tell me......how did you shampoo the carpets and mats?
Once again....a complete 180!
I'm a huge wheel-well-must-be-clean-as-heck man and those are clean!
See that duffel....been to ADS lately? I order about 90% of my stuff from there.
Tell me......how did you shampoo the carpets and mats?
Once again....a complete 180!
GregCavi
Pinnacle Detailing Owner
justin30513 said:
Thanks!! I got that last summer from ADS. I do get alot of the detailer line apc's, degreasers, and dressings. For the carpets, I just vaccumed then used apc+ and generously applied, then agitated, and extracted with a rigid vac. I used oxy clean mix on the front carpet becuase it was a little to dirty for just the apc mix.
Greg
AZ Ferrari Man
Member
Looks great!
How did you use the P0106ff, by PC?
I have not had much luck removing micro-marring with the P0106, how much do you use?
Thanks for the help!
Andrew
How did you use the P0106ff, by PC?
I have not had much luck removing micro-marring with the P0106, how much do you use?
Thanks for the help!
Andrew
GregCavi
Pinnacle Detailing Owner
AZ Ferrari Man said:
The po106ff was used via the rotary @1500 rpm. The po106ff has more cut than FPII and po85rd but finishes the very same (FLAWLESS) as both. So I can remove light and medium swirling with the po106ff and finish perfectly. I use a couple nickel size drops per section 2x2ish.
Greg