Re: Don`t just stop here Newbies!!!
I have been hesitant to post again because I am not sure of the proper location to ask my questions. I would appreciate advice as to where to ask these...
Does anyone have advice on how to apply touch up paint? I have a 2006 Mercedes CLS. The touch up paint came with paint and clearcoat. The brushes seem awfully big for the job. Do I want to use as little as possible, or try to fill in the hole of the stone chip?
I realize that "what kind of wax is best?" is an annoying question but I am looking for a good wax for Mercedes paint in Pewter. I am wondering if anyone has experience with this paint. I am not sure what I want out of the wax as far as depth, gloss, and wetness. I just want to make my car look even better. I am considering the trial size of Dodo Juice Supernatural. Any feedback will be appreciated.
Regarding the touch up paint, you need to find an automotive paint store and ask them to sell you a Sword Brush.. It`s a small brush that when wet, makes a perfect, tiny, tip at the end to apply just enough paint into that paint chip place...
What does the directions say that came with the touch up paint you purchased??? I have always had excellent results with Dr. Colorchip products, following their directions...
Also, have been an Auto Painter, and the sword brush is what we used at the shop to fix paint chips on Client`s cars, because we wanted the car to look as close to perfect as it could..
You need to warm up the paint and clear coat, I just put them in my pocket for awhile and that seems to warm them up just fine, and shake them up really well after warming them up, then go do the work..
You want to apply the paint with that brush in layers if possible, letting it dry in between.. You need to leave a little room for the 2nd stage clear coat layer, so think about that too..
Rinse the sword brush out in lacquer thinner, (which is most likely what the touch up paint is made of), and you will be fine... I use a little lacquer thinner to initially wet the sword brush, not so much it`s dripping, and while it is still
just moist, get a little paint on the tip of the brush and go immediately to the chip and start the fill process...
Assume you cleaned and dried the chip surface beforehand..
Practice on something first if you are not sure about how this works or you`re not that steady with the brush placement, etc...
Understand that even with all the preparation, application, some paint chips will not ever look perfect, and they may eventually lose the paint in the chip and you will have to do it over again.. It is not a perfect science..
Waxes ? This could take a long time to discuss..
Tha last time I use any wax because the Client wanted it, I used Finish Kare BWM 101 Hi-Temp Paste Wax, (on a recommendation from my good friend, Accumulator), and it worked great and looked great...
Dan F
