Cheap Ibrid nano alternative

[mikejames]

Hi mike i would like the link to aliexpress for baking plate and pads thxs


Enviado desde mi iPad utilizando Tapatalk

PM sent

 

[DKumarm3]

Interested as well. Please pm me the details.

 

[JustJesus]

I had seen the small pads on ebay, but never the shaft adapter.

Thanks for sharing the info!

 

[mobiledynamics]

LOL. Full disclaimer. I`m in the middle of redoing the garage setup - new Lista cabinets, etc.
The itty b1tty polishing tools is actually not for the car, but for the wrenches and ratchets so they are all nice and shiney !

 

[mikejames]

Interested as well. Please pm me the details.

PM sent

 

[mikejames]

LOL. Full disclaimer. I`m in the middle of redoing the garage setup - new Lista cabinets, etc.
The itty b1tty polishing tools is actually not for the car, but for the wrenches and ratchets so they are all nice and shiney !

You might change your mind if you give it a try.

 

[mikejames]

To save money on the rotary tool here is another option. I believe Migue has this outfit and likes it. It has great reviews on that online store that starts with A and sells for $19.61

[h=1]WEN 2305 Rotary Tool Kit with Flex Shaft[/h]

 

[ViperGuy21]

This is super cool! Please PM me details! Thanks!!

 

[Mooser]

+ another 1

Same setup I`m using and looks lit the same source for pads and "backing" plate.
I like it for taillights and small areas around emblems as well as other nooks and crannies
M

 

[JRW67]

This is great please pm links thanks

 

[LT1xL82]

This is great please pm links thanks

Samehere.

Please PM with the links.

Thank you!

 

[mikejames]

This is great please pm links thanks

PM sent

 

[TheMeanGreen]

I`ll take a PM too, please

 

[mikejames]

Samehere.

Please PM with the links.

Thank you!

PM sent.

 

[mikejames]

I`ll take a PM too, please

PM sent

 

[TheMeanGreen]

+1 !!! Great alternative, I have similar setup minus the Angle, and a flex shaft instead . Just adding as a testimony of this being a good alternative.

I give credit to Mike for helping me source some of the stuff.

How does the 1 inch backing plate hold up to the speed of the rotary?

 

[sjb89]

Very cool tools. Could someone please say where to buy them. I am interested. If can not say on post, please PM me. Thanks in advance.

 

[mikejames]

How does the 1 inch backing plate hold up to the speed of the rotary?

With a variable speed rotary it`s a non issue. You can select a very controllable speed with the backing plate and pad on. I have the Dremel 3000 rotary and depending on which pad I choose speed 2 or 3 work good for me with 1" pads. With 2" backing plate and pad I have to bump the speed up to 3 or 4.

 

[MshawnBauer]

I`m interested! Please send me the link! ��

 

[Migue]

How does the 1 inch backing plate hold up to the speed of the rotary?

Yeah pretty much what mike said. The speed is not insane , in my case with the WEN Tool I was fine with speed 1-2 and you can adjust pressure to slow it down or allow it to speed back up. The BP feels sturdy enough to handle that , just make sure you use a rotary with variable speeds.