Z-PC after SFX-2 results question

S

sillystanger

New member
I'm doing my first detail with the PC (also the first time using abrasive polishes). First round was SFX-1 w/ orange DAS cutting pad. Second round was SFX-2 w/ green DAS pad which produced really nice results... of course the results were pretty dramatic going from round 1 to round 2. Round 3 is Z-PC w/ Blue DAS pad. Now I wasn't expecting as dramatic a difference as compared to round 1 to round 2, but I'm not seeing any noticeable difference at all. I've even up'd the speed of the pc to 5-6.



So, what I'm wondering is... am I expecting too much from the Z-PC after SFX-2? Is Z-PC so similar to SFX-2 in abrasiveness that I may not be able to notice a difference? Should I perhaps try Z-PC w/ a green pad? Did I go wrong with going for Z-PC as a last step polish over SFX-3 (considering I used SFX-1 and SFX-2 in the first two rounds)? Thanks for your thoughts...
 
SFX 3 is just a glaze. You probably won't notice much with it as opposed to 1 and 2 which have swirl removing/hiding capabilities.
 
Can anyone speak to how Z-PC compares to SFX-2? (in terms of abrasiveness) I had imagined that Z-PC should be used after SFX-2 to give that final gloss. But now I'm wondering if Z-PC is essentially the same animal as SFX-2. I guess I'll continue with Z-PC. I imagine that should be fine as long as Z-PC isn't more abrasive than SFX-2, which I don't believe it is.
 
You must log in or register to reply here.
Back
Top