Would this work?

B

Bioman

New member
I'm going to detail my RX300 tomorrow and I was wondering if this was ok:



Wash - Zaino

Clay - Zaino

Polish - Meg's #80

Wax - NXT

Wax - Mother's Carnuba Cleaner Wax



I don't know if NXT should come after Mother's or I should just get rid of one of the wax's steps, since both have cleaners in them?



Thanks.
 
everything is good ( although you may want to wash after claying ) except the wax - you will have to choose either the NXT or Mothers. Both have cleaners and will remove ( give or take ) the bottom layer. If you can get a wax like #16 or #26 or S100 which has no cleaners, you can layer that on the NXT.



Hope that helps :)
 
It all sounds good except the last two. You need to choose one.



You are quite right - both have cleaners, Mothers has more as its a dedicated cleaner wax.



Mothers is a very good cleaner wax but will remove more of the #80 than the NXT, if that bothers you.



Otherwise, do a side-by-side trial on your hood as see which one looks better to you and go for it!
 
There's a lot more support for NXT on this forum, but as I said, do a side-by-side and *you* decide which looks better.



As far as durability, I suspect Mothers would have the edge, from my experience.
 
You must log in or register to reply here.
Back
Top