Where do I add VM to this process?

B

Bruce Jenkins

New member
I have a 2002 Candy Apple Red Prowler with excellent paint and minor swirls (that are reduced with each procedure) and I have been using the following products:

#9

SEPC

S100

I want to try VM and I would like your opinion as to where in the process I would add this product?

Thank you

Kimo
 
I would use it after the SEPC and before the S100. It has a bit of protectant in it so you want to use it after all your paint cleaning products. I've never used it so that advice is just academic. I'm sure Scottwax or someone else more familiar with it could give you more accurate advice. I think I'm right though. :xyxthumbs
 
Actually, I'd skip SEPC all together. SEPC is primarily a polish were as VM has the ability to remove minor swirls and scratches, but it also functions as a polish and has protection qualities of a wax.
 
I was actually worried someone would suggest I skip the SEPC only because I really like the way it sets up the S100. (Old dogs, new tricks problem (-:

But if I will get better results without the SEPC as well as eliminate a step, so be it!!
 
Skipping SEPC only saves you time. Experiment with both, use VM topped with SEPC, SEPC topped with VM and then VM alone since you already know how SEPC and S100 look like. Finish off the whole project with S100. Experimentation is the key to finding what works best in your opinion. :xyxthumbs
 
You must log in or register to reply here.
Back
Top