Using UPGP, how to remove a few streaks?

P

phil11

New member
Just looking for tips on how to remove a few streaks I made last night. This is the second layer, the first is about 2-3 months old.



Thanks for any tips.
 
Just let it sit. They should go away on their own. If not, you can buff with a MF to correct them.
 
phil11 said:
Just looking for tips on how to remove a few streaks I made last night. This is the second layer, the first is about 2-3 months old.



Thanks for any tips.
Click to expand...
Just QD after 12hrs. or wait for the next wash.
 
in the future, be careful when applying that you don't use too much. usually one spritz on the applicator for the hood and one for the roof, then maybe a spritz every two panels. applying in a circular motion seems to help prevent streaking in the future too...
 
ricka said:
in the future, be careful when applying that you don't use too much. usually one spritz on the applicator for the hood and one for the roof, then maybe a spritz every two panels. applying in a circular motion seems to help prevent streaking in the future too...
Click to expand...



Even after alot of practice, I still put too much on. The amounts you suggest seem to be spot on. It's always right after spritzing the applicator sponge with UPGP that I end up getting the streaks/high spots.



Most all of the streaks will go away with time, but even then it seems that UPGP really looks its best if you QD it after allowing 12 hours of cure time. QD'ing it will knock out any streaks and really make UPGP look gooooood.
 
Thanks for the tips. I went over it again with the sample of Ultima QD that was in the kit. 90 % of the streaks are gone, anf the others are hard to see. I will go with less next time. I plan on taking care of the wifes Tahoe next.
 
You must log in or register to reply here.
Back
Top